Modine PDP150LP Manual de Instruções

THIS MANUAL IS THE PROPERTY OF THE OWNER. PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB. Inspection on Arrival1. Inspect unit upo

106-560.4INSTALLATION - GAS CONNECTIONSGAS CONNECTIONS1. Installation of piping must conform with local building codes, or in the absence of local co

116-560.4INSTALLATION - HIGH ALTITUDE ACCESSORY KITHIGH ALTITUDE ACCESSORY KITAltitude (ft)Gas Heating Values at Altitude (BTU/ft3)USA Canada0-2,000 1

126-560.4INSTALLATION - HIGH ALTITUDE ACCESSORY KITIf the heating value of the gas being supplied is different than the values shown in Tables 11.1 an

136-560.4INSTALLATION - ELECTRICAL CONNECTIONS Amp draw data shown is operating amp draw at incoming power. For units that use a field installed acce

146-560.4INSTALLATION - OPERATIONAlthough this unit has been assembled and fire-tested at the factory, the following pre-operational procedures should

156-560.4CONTROL OPERATING SEQUENCE / UNIT COMPONENTSUpon a call for heat from the thermostat, power is supplied to the power exhauster motor. The uni

166-560.4Figure 16.1 - 30°, 60°, and 90° Downward Deflector Hoods HSSMOUNTINGHEIGHTXYYZZX60 DOWNTURN30 DOWNTURNNote:X = Feet from Heater to Start of

176-560.4DIMENSIONAL DATA - MODEL PTPPropeller Units - Model PTPFigure 17.1 - Dimensional Drawings A F H B POWER VENTERVENT PIPE CONNECTIONACCESS

186-560.4SERVICE / MAINTENANCE / TROUBLESHOOTINGGeneral MaintenanceThe unit and venting system must be checked once a year by a qualified service tech

196-560.4Model SizePower ExhausterLimit Control Switch Pressure SwitchIgniterIgnition Control (1 Stage)Combination Gas Valve (1 Stage)Ignition

26-560.4SPECIAL PRECAUTIONSSPECIAL PRECAUTIONSTHE INSTALLATION AND MAINTENANCE INSTRUCTIONS IN THIS MANUAL MUST BE FOLLOWED TO PROVIDE SAFE, EFFICIEN

Modine Manufacturing Company1500 DeKoven AvenueRacine, WI 53403 Phone: 1.800.828.4328 (HEAT) www.modinehvac.com© Modine Manufacturing Company 2014As M

6-560.4In the U.S., the installation of these units must comply with the National Fuel Gas Code, ANSI Z223.1 (NFPA 54) - latest edition and other appl

6-560.4Location Recommendations1. When locating the heater, consider general space and heating requirements, availability of gas and electrical suppl

56-560.41. Be sure the means of suspension is adequate to support the weight of the unit (see page 17 for unit weights). 2. For proper operation,

66-560.4A4. Refer to Table 6.1 for total minimum and maximum vent lengths, making the system as straight as possible. The equivalent length of a 90°

6-560.4A9. When the vent passes through a combustible INTERIOR wall or floor, a metal thimble 4" greater than the vent diameter is necessary

86-560.4Section B – Vertical Vent System InstallationB1. This section applies to vertically vented Category I vent systems and is in addition to “Sect

96-560.4Section C – Horizontal, Category III Vent System InstallationC1. This section applies to horizontally vented Category III vent systems and is